| |||||||
| The "HOW TO..." Place With the onset of Plug Builders now members of NBS, it was suggested that we put up a "How To" forum. Well, here it is. |
What have you got to say about the topic of: "Rattles !!". Here's how is started: "HI, I just wanted to pass this along because it is something that has been "
 |
| | LinkBack | Thread Tools | Display Modes |
03-04-2008, 09:50 PM
| #1 | ||
| NBS Member  Join Date: Dec 2006 Location: Brighams Cove Maine
Posts: 912
|
HI, I just wanted to pass this along because it is something that has been very successful with me. These are Rattles i made up with 44 Mag shells and a few 30 cal. 3/8" stainless balls and Copper rivets. They are in 10" yo- zuri Bonita lures. Through the years as i was testing these the only ones that took fish were the ones i put the Rattles in. Pic. 1 and 2 are the cases, some cut down some not. along with the ball Bearings and the copper rivets. Pic. 3 is soldering the rivets on. A drop of oil inside to prevent corrosion . (Not enough hands to solder and take pics. Pic. 4 is the same as 3 ??????? Duh Pic. 5 is where you have to drill the hole. The ONLY place to drill. (Dont ask How I KNOW ) These plugs are through wired !! A simple 1/2" Brad point bit with a marked out stop Or Tape will do. Pop it into the hole and putty over. They will make so much noise you'd swear they would SCARE the fish. lol. I should have got a better pic. of the lures, they are WELL used and no those are NOT my teeth marks !!! Try it you'll like it !!  Don
__________________ "I was so poor growing up that if I wasn't a BOY I'd have had nothing to play with" Piker Ancient Mariner | ||
|  |
| Ads Do NOT Show To Registered Members | |
|
| Tags |
| rattles |
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
